TM 1-1510-218-CL
N-5
ABORT START
1. CONDITION lever – FUEL CUTOFF.
2. IGNITION AND ENGINE STARTER switch –
STARTER ONLY.
3. TGT – Monitor for drop in temperature.
4. Ignition and engine starter switch – OFF after
TGT is below 750 C.
ENGINE CLEARING
1. CONDITION lever – FUEL CUTOFF.
2. IGNITION AND ENGINE STARTER switch – OFF
(1-minute minimum).
3. IGNITION AND ENGINE STARTER switch –
STARTER ONLY (15 seconds minimum, 40
seconds maximum).
4. IGNITION AND ENGINE STARTER switch –
OFF.
FIRST ENGINE START (GPU START)
1. EXTERIOR LIGHT switches – As required.
2. Propeller area – Clear.
3. Engine – Start.
4. Engine and systems instruments – Check.
5. CONDITION lever – HIGH IDLE. Monitor TGT as
the condition lever is advanced.
6. GPU disconnect – As required.
7. GEN switch – RESET, then ON.
