5-6. REMOVE/INSTALL NEEDLE VALVE - Continued.
Install Needle Valve. (Figure 5-2).
Remove packing nut and handle from new needle valve.
Apply teflon tape, to all male fittings. Be sure to wrap teflon tape in same direction of
Install the reducer and hose barb on needle valve.
Install new needle valve on pipe.
Install packing nut and handle on needle valve.
Connect filter plastic tubing to the reducer.
Check needle valve for proper operation.
Close water faucet.
Close circuit breaker CB16 located in the panelboard assemble.
Turn the WATER PUMP switch to the ON position.
Check for leaks and verify proper operations. (Refer to operating procedures contained
in paragraph 2-12. b.)