TM 55-6670-200-14&P
REPAIR PARTS AND SPECIAL TOOLS LIST
(Current as of 10 July 1975)
Section I. INTRODUCTION
C-1. Scope.
Definition
Code
This appendix lists repair parts required for op-
PA
Item procured and stocked for an-
eration and performance of direct support and de-
ticipated or known usage.
pot maintenance of the Electronic Aircraft Weigh-
PB ---
Item procured and stocked for in-
ing Scale, P/N C7500 and C46500.
surance purpose because es-
C-2. General.
sentiality dictates that a minimum
quantity be available in the supply
This Repair Parts and Special Tools List is di-
systems.
vided into the following sections:
XB
---
Item is not procured or stocked. If
a. Section Il. Repair Parts List. A list of re-
not available through salvage,
pair parts authorized for use in the performance
requisition.
of maintenance. Parts are listed in figure and item
number sequence.
NOTE
b. Section III. Special Tools List. (Not Appli-
Cannibalization or salvage may be used
cable)
as a source of supply for any items
source coded above except aircraft sup-
c. Section IV. National Stock Number and
port items as restricted by AR 700-42.
Part Number Index. A list, in ascending numerical
sequence, of all National stock numbers appear-
(2) Maintenance Code. Maintenance co-
ing in the listings, followed by a list, in alpha-
des are assigned to indicate the levels of main-
numeric sequence, of all part numbers appearing
tenance authorized to USE and REPAIR support
in the listings. National stock numbers and part
items. The maintenance codes are entered in the
numbers are cross-referenced to each illustration
third and fourth positions of the Uniform SMR
figure and item number appearance.
Code format as follows:
C-3. Explanation of Columns.
(a) The maintenance code entered in the third
position will indicate the lowest maintenance level
The following provides an explanation of col-
authorized to remove, replace and use the support
umns found in the tabular listings:
item. The maintenance code entered in the third
a. Illustration. This column is divided as fol-
position will indicate one of the following levels of
lows:
maintenance:
(1) Figure Number. Indicates the figure
Code
Application/Explanation
number of the illustration in which the item is
F
Support item is removed, replaced,
shown.
used at the direct support level.
(2) Itern Number. The number used to
D
------
Support items that are removed, re-
identify each item called out in the illustration.
placed, used at depot, mobile depot,
b. Source, Maintenance and Recoverability
specialized repair activity only.
Codes (SMR).
(1) Source Code. Source codes are as-
(b) The maintenance code entered in the
signed to support items to indicate the manner of
fourth position indicates whether the item is to be
acquiring support items for maintenance, repair or
repaired and identifies the lowest maintenance
overhaul of end items. Source codes are entered
level with the capability to perform complete re-
in the first and second positions of the Uniform
pair (i.e., all authorized maintenance functions).
SMR Code format as follows:
C-1
