TM 55-6670-200-14&P
Section
IV.
REASSEMBLY
4-13. General.
b. Install bearing assembly and box (6).
Reassembly procedures will be in accordance
c. Install board and switch assembly (1).
with standard practices for replacement of elec-
NOTE
tronic parts.
The board and switch assembly (1) in-
NOTE
cludes harness assembly (4) and switch
Reference should be made to the wiring
(5).
diagrams (figs. 4-2 through 4-9) during
d. Install spacers (2) and secure with screws.
reassembly.
e.
Install panel (1, figs. 4-14 or 4-15).
a. Assemble cover and component assembly
f. Install BATTERY VOLTAGE and CELL
and secure with screw.
BALANCE switches (3 and 1, figs. 1-2 or 1-3).
t h a t were discon-
b. Connect any wires
netted.
4-15).
c . Install power supply assembly into case
and secure with screws on bottom of carrying
case.
Connect cable assemblies (19 and 21, fig.
4-15. Milliammeter.
b. Place indicator assembly in kit and secure
a. Install milliammeter in cover assembly and
with roundhead screws on bottom of case assem-
secure with screws and nuts.
bly.
b. Connect wires to milliammeter.
or 4-15) and secure with screws at lower end of
panel (1).
Install oscillator-amplifier assembly into cover
assembly with flathead screws.
NOTE
4-17. Helipots.
After all cables are connected, plug kit
into appicable power source and press
a. Place into position in bottom of cover as-
hand down on cell while checking nee-
sembly and solder three leads as marked TOP
dle on milliammeter scale. A slight posi-
TERMINAL, MID TERMINAL, and BOTTOM TER-
tive movement of needle should be indi-
MINAL.
cated when cell is pressed.
b. Press down and secure on panel with
4-20. Calibration.
locknuts.
Refer to TB 43-180.
