TM 55-1730-201-12
APPENDIX C
REPAIR PARTS AND SPECIAL TOOLS LISTS
(Current as of 15 August 1967)
Section I. INTRODUCTION
1. SCOPE.
This appendix includes those items required for the performance of organizational maintenance of the
Maintenance Platform, Type B-1 (FSN 1730-390-5618).
2. GENERAL.
This Repair Parts and Special Tools listing is divided into the following Sections.
a. Basic Issue Items - Section II. (Not applicable)
b. Maintenance and Operating Supplies - Section III. (Not applicable)
c. Prescribed Load Allowance (PLA) - Section IV. (Not applicable)
d. Repair Parts - Section V. A list of repair parts authorized for the performance of maintenance at
organizational level in alphabetical sequence within each functional group.
e. Special Tools, Test and Support Equipment - Section VI. (Not applicable)
f. index – Section VII. This section is divided into the following parts:
(1) Federal Stock Number Index - Part 1. A list of Federal stock numbers, in ascending numerical se-
quence, cross -referenced to figure and item number.
(2) Reference Number Index – Part 2. A list of reference numbers in alpha-numerical sequence cross-
-referenced to manufacturers code, figure, and item number.
3. EXPLANATION OF COLUMNS.
The following provides an explanation of columns in the tabular lists in Section V.
a. Source, Maintenance, and Recoverability Codes (SMR).
(1) Source Code. Indicates the selection status and source for the listed item. Source codes used are:
(a) Code P. Applies to repair parts which are stocked in, or supplied from, General Service Adminis-
trational Defense Supply Agency or Army Supply System and are authorized for use at indicated maintenance
categories.
(b) Code XI. Applies to repair parts which are not procured or stocked, the requirement for which will
be supplied by use of next higher assembly or component.
(c) Code X2. Applies to repair parts which are not stocked. The indicated maintenance category re-
quiring such repair parts will attempt to obtain through cannibalization; if not obtainable through cannibali-
zation, such repair parts will be requisitioned with supporting justification through normal supply channels.
(2) Maintenance Code. Indicates the lowest category of maintenance authorized to install the listed
item. The maintenance code used is:
Code O - Organizational Maintenance
31
