SECTION I
INTRODUCTION
1.
Scope
Code
Explanation
is procured and stocked and can be assembled
This manual contains a list of repair parts and special
by units at indicated maintenance categories.
tools required for the performance of direct support,
AH -
Applies to parts which can be replaced at
general support, and depot maintenance for Landing
organizational
category
but
which
are
Control Central AN/TSQ-71A.
NOTE
assembled and repaired at the general support
category.
No special tools, test, and support equipment are
AD -
Applies to parts which can be replaced at
required.
organizational
category
but
which
are
2.
General
assembled and re-paired at the depot
maintenance category.
X1 -
Applies to parts which are not procured or
This repair parts and special tools list is divided into four
stocked, the requirements for which will be
principal sections.
a. Repair Parts for Direct Support, General
supplied by use of next higher assembly or
Support, and Depot Maintenance - Section II. A list of
component.
X2 -
Applies to repair parts which are not stocked.
repair parts authorized for performance of maintenance
The indicated maintenance category requiring
at direct support, general support, and depot categories.
b. Federal Stock Number Cross-Reference to
such re-such parts through cannibalization. If not
obtainable through cannibalization such repair
parts will be requisitioned with supporting
numbers to index numbers.
justification through normal supply channels.
c. Figure and Item Number Cross-Reference
(2) Maintenance code, column 1B. The
lowest category of maintenance authorized to install the
items to line items by index numbers. The line item
listed item is noted here.
index numbers appear in the description column. The
index number for an item will be the same for that item
Code
Explanation
in all repair parts lists for this equipment.
d. Reference Designation Cross-Reference to
0 ...................... Organizational maintenance
F...................... Direct support maintenance
designations to index numbers.
H ..................... General support maintenance
3.
Explanation of Columns
D ..................... Depot maintenance
The following is an explanation of the columns in section
(3) Recoverability code, column 1C. The
a. Source, Maintenance, and Recoverability
information in this column indicates whether
Codes (SMR), Column I
unserviceable items should be returned for recovery or
(1) Source code, column 1A. The
salvage. Recoverability codes and their explanations
selection status and source for the listed item is shown
are as follows:
in the column. Source codes and their explanations are
NOTE
as follows:
When no code is indicated in the recoverability
column, the part will be considered expendable.
Code
Explanation
P-
Applies to repair parts that are stocked in or
Code
Explanation
supplied from GSA/DSA, or Army supply
R-
Applies to repair parts and assemblies which are
system, and authorized for use at indicated
economically repairable at DSU and GSU
maintenance categories.
activities and normally are furnished by supply
M-
Applies to repair parts which are not procured or
on an exchange basis.
stocked but are to be manufactured at indicated
maintenance categories.
A-
Applies to assemblies that are not procured or
stocked as such but are made up of two or
more units, each of which carries an individual
stock number and description and
2
