TM 10-8415-206-12&P
4-12. VISOR TRACKS AND SPACERS - Continued
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
NOTE
Visor housing assembly uses 3 size screws. Short screw goes
into the center hole of the visor track. Medium goes thru the top
hole of the visor housing and visor track and the long screw
goes thru the bottom hole of the visor housing and visor track.
3. Visor tracks
a. Install tapered spacers (12) and tracks
Insure that largest
and spacers
(11) to helmet shell (13) with two
thickness of tapered
screw assemblies, short (10) and
spacers are installed
tighten.
facing bottom of visor
housing.
b. Install visor (9) in visor tracks (11).
c. Install spacers (8).
d. Install visor housing (7) using two
long screw assemblies (6) and two
medium screw assemblies (5). If visor
binds, add additional flat spacers
until binding stops.
e. Install lockstem (4) in visor if removed.
f. Install washer (3) cavity side down in
button head (2) and install button
head (2).
g. Install lockstem center screw (1).
4-22
