TM 10-8415-206-12&P
3-3. VISOR AND GUARD LOCK ASSEMBLY
This task covers:
a. Inspection
b. Adjustment
INITIAL SETUP
Tools
Screwdriver, flat tip, 4 inch, 1/4 in. wide blade
Personnel Required
Aviation Life Support Equipment
(ALSE) Specialist or
MOS with ASI of 02
LOCATION/ITEM
ACTION
REMARKS
NOTE
The visor assembly is retractable and provides protection from
glare, dust, and wind blast. It is made of plastic. Two shades
are available, neutral and clear. A spacer is cemented to each
side of visor and slides into the visor track.
The guard lock assembly is attached to the visor and permits
visor to move up or down, after the lock's button head is
rotated approximately 114 turn in a counter-clockwise
direction. The guard lock assembly consists of the following
parts: Left hand thread Lockstem center screw, plastic button
head, plastic washer and button stem.
REMOVAL
1.
Lockstem center
Remove by rotating in a clockwise
screw (1)
direction.
2.
Button head (2)
Remove by rotating in a counter-
clockwise direction.
3. Button head
Remove from button head (2).
washer (3)
3-5
