TM 10-6640-216-13&PB-3. EXPLANATION OF COLUMNS IN THE MAC - SECTION II - continued.d.Column4,MaintenanceCategory.Column 4 specifies, by the listing of a work time figure inthe appropriate subcolumn(s), category of maintenance authorized to perform the function listed inColumn (3). This figure represents the active time required to perform that maintenance function atthe indicated category of maintenance. If the number or complexity of the tasks within the listedmaintenance function vary at different maintenance categories, appropriate work time figures will beshown for each category. The work time figure represents the average time required to restore an item(assembly, subassembly, component, module, end item, or system) to a serviceable condition undertypical field operating conditions. This time includes preparation time (including any necessarydisassembly/assembly time), troubleshooting/fault location time, and quality assurance/quality controltime in addition to the time required to perform the specific tasks identified for the maintenancefunctions authorized in the maintenance allocation chart. The symbol designations for the variousmaintenance categories are as follows:C . . . . . . . . . . . . . . . . . Operator or crewO. . . . . . . . . . . . . . . . . Unit MaintenanceF . . . . . . . . . . . . . . . . . Direct Support MaintenanceH . . . . . . . . . . . . . . . . . General Support MaintenanceD . . . . . . . . . . . . . . . . . Depot Maintenancee.Column5,ToolsandEquipment. Column 5 specifies, by code, those common tool sets (notindividual tools) and special tools, TM DE, and support equipment required to perform the designatedfunction.f.Column 6, Remarks. This column, when applicable, contains a letter code, in alphabetic order,which shall be keyed to the remarks contained in Section IV.B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENTREQUIREMENTS, SECTION III.a.Column 1, Reference Code. The tool and test equipment reference code correlates with a codeused in the MAC, Section II, Column 5.b.Column2.MaintenanceCategory.The lowest category of maintenance authorized to use thetool or test equipment.c.Column3,Nomenclature. Name or identification of the tool or test equipment.d.Column4,NationalStockNumber. The national stock number of the tool or test equipment.e.Column5,ToolNumber. The manufacturer’s part number.B-5. EXPLANATION OF COLUMNS IN REMARKS, SECTION IV.a.Column1,ReferenceCode. The code recorded in the MAC, Section II, column 6.b.Column2,Remarks. This column lists informat ion pertinent to the maintenance function beingperformed as indicated in the MAC, Section II.B-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business