TM 1-8415-215-12&P
12.
Release pressure on top of helmet at the
-Raise visors.
end of three to five minutes.
-Adjust rear-closure hook-and-pile
fasteners and hanger tab of reten-
tion assembly; adjust earcups;
tighten nape strap and chin strap
as required.
13.
Check fit.
-Check for hot spots or pressure
points.
-TPL can be reheated and fitting
procedures repeated. Remove
masking tape from rear hook
fasteners before reheating.
-TPL layers can be laundered or
dry cleaned. Replace two-sided
tape after laundering.
-In some cases it will be necessary
to remove one or more inner
plastic layers from TPL to achieve
an optimum fit. A minimum of two
layers should be retained.
Change 2
3-2.3/(3-2.4 blank)
*U.S. GOVERNMENT PRINTING OFFICE: 1994 - 555-028/00348