TM 1-8415-215-12&P
Table 2-1. Operator's Preventive Maintenance Checks and Services
NOTE
Within designated intervals, these checks are to be performed in the order listed.
The item number column shall be used as a source of item numbers for the “TM
Number” column on DA Form 2404, in recording results of PMCS.
LEGEND
B - Before
A - After
D - During
W - Weekly
B
D
A
W
Upper Front
1.
Visor Locks
Inspect visor locks to make sure
Visor locks fail
they lock in the retracted position.
to lock visors in
If defective visors lock refer to
retracted position.
Chapter 3, Maintenance.
2.
Visors and
Lower and raise visors to make
Visors sticks or
housing
sure they move freely in their tracks.
fail to move
If defective visors or visor tracks,
freely in tracks.
refer to Chapter 3, Maintenance.
Inspect visors for dust, grease,
and other defects.
Clean visors,
using a clean, damp cloth, to
remove dust and dirt.
NOTE
Use a mild soap solution to
remove grease, oil and
perspiration from visors.
Item To Be
Inspected
Equipment will be
reported not ready/
Available if:
INTERVAL
ITEM
NO.
PROCEDURES
Check for and have repaired
or adjusted as necessary:
2-10
