TM 1-1510-225-10 3B-49 Table 3B-9.  CDU Annunciations and Scratchpad Messages  (Continued) ANNUNCIATION /SP MESSAGE INITIATING CONDITION RESET MECHANISM LOCATION BLINKING NOT CLEARABLE CDU MSG ALERT enter utc On power up if time is not available and crew has not entered time or if bus control is switched with time not valid. Clear key or entry of time or return of valid time. A N ENTER UTC/DATE Attempt to start one of the times without a valid UTC and Date available in system. Clear key SP A ENTER WAYPOINT Attempt to enter an alternate flight plan parameter prior to entering the waypoint or attempt to enter a flight plan course when no TO exists. Clear key SP A ERF IN PROCESS Attempt to initiate another action on the V/UHF when an ERF is in process. Clear key SP A exiting hold Active hold is canceled by deletion of the H attribute. Hold fix is crossed. AL N fg8 active Figure 8 pattern is currently being executed. Figure 8 pattern canceled. A N X FG8 IS ACTIVE Attempt to delete or modify the figure 8 fix; delete MFP attribute, modify flight plan course, insert a PPSN hold, or insert a waypoint at the active waypoint during pattern execution. Clear key SP A FINAL APPR CRS XXX°  Direct-To is made to the FAF of an approach. Clear key or selecting CRS entry on the Flight Plan page. SP N FL005 FT MINIMUM Attempt to enter VNAV or alternate flight plan altitude less than FL005. Clear key SP A FPLN FULL Attempt to insert more than 60 waypoints into the flight plan. Clear key SP A GROUND ONLY Attempt to perform a ground operation during flight. Clear key SP A hold active Hold is currently being executed. Hold canceled. A N X HOLD DEFINED Attempt to attach a pattern on a waypoint with a Hold attached or an attempt to insert an offset when a holding fix is the TO waypoint. Clear key SP A