TM 1-1510-218-10
3C-82
Figure 3C-27. Start 1 Position/Time Initialization
Table 3C-19. Start 1 Position/Time
Initialization Procedures
NO.
DESCRIPTION/FUNCTION
1
Enter airport identifier in Scratchpad.
2
Press Left Line Key 1.
3
Verify the Lat and Long.
4
Verify UTC date, change as required.
5
Verify UTC time, change as required.
6
Verify current system datum.
7
Scroll to Start page 2.
2. If the initial position or time is
incorrect, enter the correct values and
initialize the GPS on the Start 2 page.
Refer
to
Figure
3C-28
and
Table 3C-20.
NOTE
Typically the GPS will not have to be
initialized. The FMS-800 automatically
commands the GPS into navigate mode
upon power-up and the GPS receiver will
then attempt to acquire satellite signals. If
the GPS receiver fails to acquire satellites,
reload the GPS almanac.
Figure 3C-28. Start 2 Navigation/Initialization
Table 3C-20. Start 2 Navigation/
Initialization Procedure
NO.
DESCRIPTION/FUNCTION
1
Command GPS initialization.
2
Scroll to Start 3 page.
3. Scroll to the Start 3 page and verify the
effectivity date of the ICAO data base
is correct. Refer to Figure 3C-29 and
Table 3C-21. If a new flight plan and
mission data are to be entered
manually, select ERASE FPLN. If a
new plan is to be loaded from the
cartridge, first enter the desired flight
plan number or access the Alternate
Flight Plan Catalog and select the
desired
flight
plan
(requires
confirmation select twice). After
loading is complete, select FPLN
REPLACE. This transfers the
alternate flight plan data into the
active flight plan so that both plans are
identical at the beginning of the
mission. The crew may select FLT
/DATA LOAD to load all remaining
preplanned mission data, including the
radio presets, V/UHF HAVE QUICK II
MWOD's, FMT's, SINCGARS net
identifiers, and user waypoint and
markpoint lists.
