TB 43-0149
(g) The female connector of the cable i placed
the mast is raised, the free guy cable is attached to its
stake (figure 42), and all guy cables are adjusted and
above the clevis at the top of the mast and secured with
tightened until the mast is plumb (figure 43). Two turns
a cotter pin. The obstacle light lead is plugged into this
of the short anchor cable are made around the base of
connector (figure 39). The length of the 2 guy cables
the mast and the ends are attached to the anchor stake
previously attached to the ground stakes are adjusted to
approximately the length required when the mast is
erected. The mast can now be raised.
(h) With one man located at a point of the mast near
the center and another man in position to pull and guide
Figure 39. Installation of power cable for mast mounted obstance light.
27
