TM 55-1510-219-10 3. Ignition     and     engine     start     switch-ON. Propeller    should    begin    to    rotate    and associated IGN ON light should illuminate.  Associated FUEL PRESS light should extinguish. 4. Condition lever (after N1 RPM  stabilizes, 12% minimum)-LOW IDLE. CAUTION Monitor  TGT  to  avoid  a  hot  start. If  there  is  a  rapid  rise  in  TGT,  be prepared  to  abort  the  start  before limits     are     exceeded.          During starting,  the  maximum  allowable TGT is 1000°C for five seconds.  If this limit is exceeded, use ABORT START procedure and discontinue  start.    Enter  the  peak temperature  and  duration  on  DA Form 2408-13. 5. TGT and N1-Monitor (TGT 1000°C maximum, N1 52% minimum). 6. Oil pressure-Check (60 PSI minimum). 7. Ignition and engine start switch-OFF after TGT stabilized. 8. Condition   lever-HIGH      IDLE.      Monitor TGT as the condition lever is advanced. 9. Generator switch-RESET, then ON. 8-24.  SECOND ENGINE START (BATTERY START). 1. First engine generator load-50% or less. 2. Ignition     and     engine     start     switch-ON. Propeller    should    begin    to    rotate    and associated IGN on light should illuminate. Associated    FUEL    PRESS    light    should extinguish. 3. Condition   lever   (after   N1   RPM   passes 12% minimum)-LOW IDLE. CAUTION Monitor  TGT  to  avoid  a  hot  start. If  there  is  a  rapid  rise  in  TGT,  be prepared  to  abort  the  start  before limits     are     exceeded.          During starting,  the  maximum  allowable TGT is 10000C for five seconds.  If this limit is exceeded, use ABORT START procedure and discontinue  start.    Enter  the  peak temperature  and  duration  on  DA Form 2408-13. 4. TGT and N1-Monitor (TGT 1000IC maximum, N1 52% minimum). 5. Oil pressure-Check (60 PSI minimum). 6. Ignition and engine start switch-OFF after TGT stabilized. 7. Battery charge light-ON. 8. Second    engine    generator-RESET,    then ON. 9. Inverter   switches-ON,   check   INVERTER lights OFF. 10. Condition levers-As required. 8-25.  ABORT START. 1. Condition lever-FUEL CUTOFF. 2. Ignition and engine start switch-STARTER ONLY. 3. TGT-Monitor for drop in temperature. 4. Ignition and engine start switch-OFF. 8-26.  ENGINE CLEARING. 1. Condition lever-FUEL CUTOFF. 2. Ignition   and   engine   start   switch-OFF   (1 minute minimum). CAUTION Do not exceed starter limitation of 30   seconds   ON   and   5   minutes OFF for two starting attempts and engine clearing procedure.  Allow 30  minutes  off  before  additional starter operation. 3. Ignition and engine start switch-STARTER ONLY (15 seconds minimum, 30 seconds maximum). 4. Ignition and engine start switch-OFF. 8-27.  FIRST ENGINE START (GPU START). 1. INS-As required. CAUTION Mission  control  switch  should  be OFF prior to start. 8-13