Headband Suspension Adjustment

Section III. OPERATING UNDER USUAL CONDITIONS

TM-10-8415-206-12P Helmet Flyer s Protective Manual
Page Navigation
17

TM 10-8415-206-12&P 2-3. OPERATING PROCEDURE-Continued e. Headband Suspension Adjustment. NOTE This adjustment loosens or tightens the headband. To obtain maximum helmet retention and for stability, the headband should be tightened until snug around the head. Be certain the buckles (one on each side) are vertical or at right angles to the suspension when making this adjustment. (1) To Tighten: (a) Pull on free end of strap (1) in the adjustment buckle (2). (b) Pull on free end of other strap (1) in adjustment buckle (2). (c) Repeat steps (a) and (b) until headband fits snugly around the head. (2) To Loosen: (a) Slide lockbar (1) towards back of adjustment buckle (2). (b) Push free end of strap (3) towards rear of adjustment buckle (2). (c) Repeat steps (a) and (b) to loosen other adjustment buckle (4). (d) Repeat steps (a), (b) and (c) until headband fits properly. Change 2 2-11

Privacy Statement
Press Release
Contact