(2) Attach folding brace of manual control
panel to center brace of tank support assembly, using
screws (54) and nuts (53).
(4) Attach brake cable assembly (11, fig. 4-9)
to brake lever (16, fig. 4-10) and valve rod (15) to valve
lever (17). Place clevis pins (3) through slots in lever
sides, connecting cable and lever clevis (13) to actuation
arm of lever. Place washers (2) over clevis pins, and
Folding braces may be attached to either the
secure with cotter pins (1).
upper or lower pair of holes in tank support
center brace. Use upper holes for UH-1B
(5) Reattach cable housing clamp (9) and
installation, and lower holes for UH-1D
spacer (8) to brake lever position on control panel using
screw (6), washers (5) and nut (4).